Forums PSPGen

hum, i been through the french sections of the forum, but i'm realli confused on how to do the sound reactive trigger mod with a switch and the internal build Go!cam
can someone give me details on it?
(maybe with some picture? easier to understand)
Please and thank you

Hi!

here's the best link (in my opinion) by Roro3030
try a google translation

Part 2: The motherboard
is unclear, cause the picture's too small, i can't really see which leg he mounted the wire to, and he didn't really explain how to connect the wires to the Go!cam

can you explain it?

Hi,
you just have to solder the wire as if it was connected outside.
ie: 1st pin of the usb port located on the mobo with the 1st pin of the cam conector. Same for the other ones.

Just be carefull and don't forget the ground

hum... this will probably make me sound retarded.... but yea i dont understand what u mean by ground?

doesn't that mean a wire that'll lead extra electricity to nowhere so that it wont harm ur electronic equipment?

so i'm suppose wire a wire to the go!cam that goes nowhere?

and what about the trigger mod?.... i know there r tons out there and it sounds like i haven't done my research, but i'm using a 3000 model, and all the tutorials i can find r like for mostly phats and sometimes slime, but never brite

ground can be assimilate to a 0 Volt (or the négative pole if you prefer)

For the trigger there isn't many differences between slim and brite.
Open your brite and you'll see what i mean

kk, thx~! ur a BIG help

you're welcome